Description
Easily build your own NAS / Media-server based on Raspberry Pi 4
TOP Raspberry Pi Project 2020! @Novaspirit Tech https://youtu.be/BXidc8zdNis

Description
-
mount up to 4x 2.5″ HDD or SSD (max height 9.5mm)
-
Software RAID 0/1/5
-
HDD/SSD status LED online/activity/fault
-
Utilizes two independent USB3 buses on Raspberry Pi 4
-
DC Type (5.5/2.5) power input with support for 2.5inch drives and Raspberry Pi 4
-
HDD suspend mode supported
-
UASP support
-
Capacity up to 16TB (e.g. 4x 4TB SSD)
-
PWM controlled fan for HDD heat dispatching
-
OLED display for IP Address/Storage info
-
does only work with Raspberry Pi 4
-
easy to set up and run
-
Size (L/W/H) 94 x 70 x 173 mm
Product Content
-
Quad SATA HAT board
-
SATA HAT Top board, management board including OLED status display and active cooling
-
HAT connector cable
-
ecoPI Quad Sata case (aluminum)
-
USB3.0 dual bus connector
-
heat sink kit with PWM fan for Raspberry Pi 4
What is so special?
-
smaller than a bottle of Coke
-
fits into the smallest book shelf
-
low noise PWM fans
-
high capacity up to 16TB
-
economic as surveillance system
-
fast as media server
-
backup server for your home
-
OLED display for basic status information
-
nice lean design
IMPORTANT:
You need to use a >=40W 12V DC Power supply to run this NAS!
Raspberry Pi 4 2/4GB is recommended
->>Rock Pi 4 Model C+ can be used as replacement<<-
BUT PLEASE NOTE:
The M.2 (M) 2230 up to 2T M.2 NVME SSD via PCIe 2.0 x4 interface must not be populated in this setup!
Just add your Raspberry Pi 4 (Rock Pi 4C+) to this Kit and your NAS is complete and it really looks great!











Reviews
There are no reviews yet.